Jump to content

Garden Tractors and Parts on eBay



Photo
- - - - -

Toro Power Washer Briggs and Stratton

carb pressure washer toro briggs and stratton

  • Please log in to reply
2 replies to this topic

#1 Corylwillrise OFFLINE  

Corylwillrise
  • Member
  • Member No: 95744
  • 0 Thanks
  • 1 posts
  • Location: Morris Plains

Posted August 28, 2019 - 06:12 PM

I got this power washer for 40 dollars. It never ran consistently and the previous owner told me it needed a new pump. So I re[placed the pump and it would still stall sometimes, so I replaced the gas cap to eliminate a possible vacuum. It still had problems, so I replaced the carburetor, the spark plug, the fuel line, and the air filter. At this point it would only idle and as soon as you pull the trigger it stalls. Then I removed all the corrosion off the fly wheel magnet for the magneto and now it will usually start on the first pull but as soon as you pull the trigger for the gun, it stalls. Keep in mind I replaced the pressure washer pump! it doesn't make any sense. Any help would be greatly appreciated. Thanks!



#2 secondtry ONLINE  

secondtry
  • Senior Member
  • Member No: 83632
  • 4395 Thanks
  • 2690 posts
  • Location: Washington State

Posted August 28, 2019 - 09:22 PM

I don't remember the specifics but pressure washers have what is called an unloader valve. check that out. Also I would try removing the spray tip and see if it would run unrestricted.   Don



#3 Dcarr OFFLINE  

Dcarr
  • Senior Member
  • Member No: 95176
  • 428 Thanks
  • 230 posts
  • Location: Arizona

Posted August 28, 2019 - 11:34 PM

I agree with Don . There has to be a hydraulic lock somewhere  in there .







Also tagged with one or more of these keywords: carb, pressure washer, toro, briggs and stratton

Top