When I removed thr transaxle pully it had 3 shims between the in and out sides of the pully and 3 shims outside the outer side, are the 3 extra shims for a new belt to widen the spacing or? And this is a vari-drive.
Transaxle pully shim question
Started by
greencoach47
, May 31, 2011 08:33 PM
3 replies to this topic
#1
OFFLINE
greencoach47
-
- Senior Member
- -GTt Supporter-
- Member No: 3236
- 8 Thanks
- 85 posts
Tractorholic
- Location: Northern Ca.
Posted May 31, 2011 - 08:33 PM
#2
OFFLINE
MH81
-
- Senior Member
- -GTt Supporter-
- Contributor
- Member No: 802
- 30054 Thanks
- 29761 posts
Proud to be Deplorable
Posted May 31, 2011 - 08:36 PM
Yes, as the belt wears, you remove shims. When you put in a new belt, you put in some shims. I think you leave one out tho, as both the ones I've played with had OEM paint on one, like it was on the outside from the factory.
- greencoach47 said thank you
#3
OFFLINE
IamSherwood
-
- Senior Member
- -GTt Supporter-
- Contributor
- Member No: 2066
- 8411 Thanks
- 7697 posts
Elf guardian
- Location: Northern Ontario
Posted May 31, 2011 - 08:37 PM
Yes they are.
There is a post here somewhere by Doug(DH1) that describes very well the adjustment procedure.
I think I know where it is.
There is a post here somewhere by Doug(DH1) that describes very well the adjustment procedure.
I think I know where it is.
#4
OFFLINE
IamSherwood
-
- Senior Member
- -GTt Supporter-
- Contributor
- Member No: 2066
- 8411 Thanks
- 7697 posts
Elf guardian
- Location: Northern Ontario
Posted May 31, 2011 - 08:40 PM
- greencoach47 said thank you
