9 replies to this topic

[DanP]

I am putting a electric power lift on my MF10 and there is a switch that raises and lowers it. I am not sure where it goes. I would assume the installtion instructions would have told you where to drill the hole. I would guess it went on the dash or down on the plate by the hood latch. I saw a photo of a MF10 on this site the other day with a hole in the dash to the left of the steering wheel and down a little. Does anybody know for sure?

[ducky]

I am not sure of the correct location but I am sure someone will be by shortly with the answer.

[broken2]

I have a mf12 that originally had the electric/hydraulic lift. The electric pump/lift cylinder were missing and replaced with a manual lift handle before I got it but the control switch and solenoid are still there. Here's some pictures of my dash/switch. Hope it helps. I would love to see some pics of yours when you get it set up, I've never seen a complete power lift on a mf10/12.

Attached Thumbnails

• 

[MH81]

Hey Dan, could you do me a favor?
Could you measure left edge of the dash and bottom of the dash to center of the hole.
That would let everyone know where to drill the hole to mount it.

[DanP]

Broken2 that is what I needed, thanks. Can you tell me where the solenoid is mounted?

[DH1]

I have a mf12 that originally had the electric/hydraulic lift. The electric pump/lift cylinder were missing and replaced with a manual lift handle before I got it but the control switch and solenoid are still there. Here's some pictures of my dash/switch. Hope it helps. I would love to see some pics of yours when you get it set up, I've never seen a complete power lift on a mf10/12.

[ATTACH=CONFIG]27228[/ATTACH][ATTACH=CONFIG]27229[/ATTACH]

As soon as I saw these pictures I knew I seen that "up dwn" decal before, looked around at my old Massey parts in the garage and found this.

[HowardsMF155]

I am putting a electric power lift on my MF10 and there is a switch that raises and lowers it. I am not sure where it goes. I would assume the installtion instructions would have told you where to drill the hole. I would guess it went on the dash or down on the plate by the hood latch. I saw a photo of a MF10 on this site the other day with a hole in the dash to the left of the steering wheel and down a little. Does anybody know for sure?

Hey Dan, how about some pictures and some information about what you are installing.
Howard

[DanP]

@HowardsMF155 Check out my thread on "MF10 restoration" I have the whole story there.

[broken2]

Hey Dan, could you do me a favor?
Could you measure left edge of the dash and bottom of the dash to center of the hole.
That would let everyone know where to drill the hole to mount it.

I'll get some measurements when I get home from work tonight.

[broken2]

Broken2 that is what I needed, thanks. Can you tell me where the solenoid is mounted?

I'll get some pics of the solenoid tonight.