Old Tyme Days Eastern Extra...
Kster526 - Aug 24, 2020 09:29 AM
1967 Jacobsen built to home...
426tractorguy - Jul 10, 2020 06:26 PM
How To Repair Worn Splines...
TomR - Jun 24, 2020 02:37 PM
GTtalk's Guide to Buyin...
426tractorguy - Jun 22, 2020 02:56 PM
Jacobsen Battery Box Hold D...
426tractorguy - Jun 22, 2020 02:44 PM
Father son project
426tractorguy - Jun 22, 2020 01:54 PM
Tractor of the Month - Alice by KennyPfeatured tractor tractor of the month alice alice tractor
]I'm going to nominate Alice for this month, I picked the tractor up the end of July, 2015. When I first saw it, I saw the potential to make a good working tractor from the mods already done to her. She was owned by someone into pulling and the frame had been cut to accept a Kohler Magnum 18, which I had sitting in the shop. This is what she looked like the day I brought her home.
She was a 716-6 speed, I wanted a hydro. So everything from the BGB back was removed. It took me until mid-October to get her put together. I made a frame for an Eaton 11/Peerless 2500 out of a Ford LGT 165. Even set up the foot pedal drive. I moved the brake pedal to the LH side while I was at it. Next was using the 3-Point rock shaft off a Sears FF tractor. I found an MTD drive shaft through this forum, this has u-joints and not the discs like the AC uses. Added in an oil cooler since I did not have a fan to cool the hydro. Since getting it going, I have installed a two-spool valve from a MF. Rear fenders are early Sears/Roper. Seat slide is from the Ford. I have a tool box under the seat. I also had to extend the hood and front frame 4" to make room for the exhaust.
Before taking her to Ball Hollow Plow days last Spring, I bought some tri-ribs for the front and a set of BKT 26-12's for the rear. Made a pair of suitcase weights for the front out of lead, 40 lbs. each. The rears are full of washer fluid, each one weights 120 lbs. I have Sears 40 lb. weights on the outside, and Gravely two-piece 40 lb. weight installed inside each wheel. I have no spinning issues!
I have also built a canopy for the hotter days. Implements I have built that I use on the 3-point are:
Modified a Brinly 10" sleeve hitch plow to 3-point
3-Point to Sleeve Hitch Adapter
I also have a Brinly 12" plow that I have no problem pulling.
Here's some pics.
- grand, Craig., jimbobbillyray and 6 others have said thanks