1967 Jacobsen built to home...
426tractorguy - Jul 10, 2020 06:26 PM
How To Repair Worn Splines...
TomR - Jun 24, 2020 02:37 PM
GTtalk's Guide to Buyin...
426tractorguy - Jun 22, 2020 02:56 PM
Jacobsen Battery Box Hold D...
426tractorguy - Jun 22, 2020 02:44 PM
Father son project
426tractorguy - Jun 22, 2020 01:54 PM
Feature Tractor For August...
426tractorguy - Jun 22, 2020 09:15 AM
Massey Ferguson MF10 Narrow Front
I have pulled it at garden tractor pulls and it has done quite well for itself. This was the first pull I did with it and I had one foot ready on the clutch because I didn't know if it would be light in the front end pulling with the taller rear tires.
Here are some pictures of how I built the narrow front. I used the same basic design as the narrow Allis B-10. I welded a 1 inch shaft down from the bottom side of the Massey frame. I put a 1 inch hole in a piece of 3 inch wide by 1/4 inch thick flat steel and welded that across the bottom of the tractor frame to help support the 1 inch shaft.
This picture shows the heavy wall 1 inch inside diameter tube that I use to support the front axle. The steering arm is welded to the top of the tube and with a turnbuckle and rod runs back to the steering gearbox. The large washer you see at the top does two things. First there is a brass thrush washer between that large washer and the frame to provide a bearing surface. Also if you notice the bolt, spacer, and washer next to it, that prevents the tube from coming off of the 1 inch shaft if you were to raise the front end up like from popping a wheelie.
This picture gives a view of the front end with one of the front wheels installed. I use 6 inch diameter wheelbarrow rims and cut the bearing tube to be just as wide as the rim itself and then reinstall the bearings. On this tractor I used 4.00x6 tri rib tires. I use this combination of 4.00x 6 front tires and 6.70 x 15 rear tires for two resons. First the taller rear tires raise the tractor up enough that I can put the narrow front wheels under the front end and the tractor will still sit level. The other resaon is that these tires have the same size ratio as the real farm tractors and help make it more believable.
- Genem, Kster526, Mark 149 J. and 2 others have said thanks