Bolens G-10 1055
Posted May 04, 2010 - 09:12 PM
Posted May 05, 2010 - 05:17 AM
Are you shure the Free wheeling pin is in place?
If you have some pictures that would be useful as well.
The free wheeling pin is located on the left rear axle when facing the front of the tractor.
Posted May 05, 2010 - 05:57 AM
Posted May 05, 2010 - 06:24 AM
Just like Brian mentioned check the free wheel pin, it gets ya every time.
Posted May 05, 2010 - 06:50 AM
Hopefully its the freewheel pin as its the easiest fix. We always like easy the easy fix.
Posted May 05, 2010 - 11:37 AM
Posted May 05, 2010 - 12:02 PM
Edited by fonz3482, May 05, 2010 - 12:14 PM.
Posted May 05, 2010 - 04:41 PM
I checked free wheel pin it's in place. If both drive belts are not on can that affect the clutch to switch gears?
How many Belts do you have on the tractor?
There should be 1 PTO belt (the one closest to the engine)
You should have 1 Drive Belt. The only bad thing about the G-10's is on the earlier models, you have to shut the engine down to switch from Low to High Range. Low range is on the pulley farthest away from the engine, and High Range is the middle groove. Later models of the G-10's Had 4 belts with the speed range lever built into the transmission. We first have to figure out what system your G-10 is and go from there :)
Posted May 05, 2010 - 04:45 PM