Jump to content

Garden Tractors and Parts on eBay



Photo
- - - - -

Onan Bf-Ms Roper RT16-T is Running!


  • Please log in to reply
7 replies to this topic

#1 John Arsenault OFFLINE  

John Arsenault
  • Senior Member
  • Member No: 76279
  • 2,918 Thanks
  • 1,321 posts
  • Location: Maine

Posted February 14, 2018 - 07:47 AM

First off I want to shout out to  Texas Deere and Horse For assisting me with my crank shaft service it was very awesome of you to offer to help me, a feel your a part of this success.

 

Took me a whole lot of parts fishing to get everything needed to get this thing running again. But I got it fired up for the 1st time yesterday and she purrs. I am surprised with all the assembly lube and oil that this thing didn't smoke out the neighborhood. 

 

https://www.facebook...02098889807159/

 

Video above.

 

20180212_122145.jpg

 

 

Now I just need to fine tune the carb and all finish assembling. 


  • olcowhand, KennyP, Traill95 and 3 others have said thanks

#2 chieffan OFFLINE  

chieffan
  • Senior Member
  • Contributor
  • Member No: 62695
  • 11,309 Thanks
  • 7,095 posts
  • Location: SW Iowa

Posted February 14, 2018 - 08:24 AM

Good job.  I bet that is one loud puppy with straight pipes that short.


  • KennyP, boyscout862 and Mark 149 J. have said thanks

#3 KennyP OFFLINE  

KennyP

    FORDoholic

  • Super Moderator
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 2253
  • 40,857 Thanks
  • 47,081 posts
  • Location: Collinsville, Oklahoma

Posted February 14, 2018 - 08:37 AM

Get it idling right and slow and they'll think you have a Harley!


  • boyscout862, Leonard VanCamp and Mark 149 J. have said thanks

#4 John Arsenault OFFLINE  

John Arsenault
  • Senior Member
  • Member No: 76279
  • 2,918 Thanks
  • 1,321 posts
  • Location: Maine

Posted February 14, 2018 - 09:33 AM

Good job.  I bet that is one loud puppy with straight pipes that short.

I fire it up before the rebuild with the straight pipes it was not as bad as I one would think. But this time I put the exhaust on before pushing it out of the garage and starting it. I  took take the exhaust off to diagnose the back firing issue I had before the rebuild then found it was only a 1 cyl onan. Its firing on both cylinders now! 

 

20180213_133333.jpg


  • olcowhand and Mark 149 J. have said thanks

#5 John Arsenault OFFLINE  

John Arsenault
  • Senior Member
  • Member No: 76279
  • 2,918 Thanks
  • 1,321 posts
  • Location: Maine

Posted February 14, 2018 - 09:51 AM

Get it idling right and slow and they'll think you have a Harley!

I look forward to it, right now just doing the high idle for 10 minute things and getting it broke in, going to run it some more today change the oil, go over a few things and then start getting this tractor ready for duty. I didn't have but the end of yesterday to tinker with it because I been busy with work. 

 

https://www.facebook...02097766473938/

 

Here is one of just idling at a slightly increased idle, so far so good no popping though the exhaust and sputtering like it was doing.

 

Still would have been cheaper and easier to put in a Subaru  Robin EX40 engine in and it would have came with a warrantee....lol 

 

20171107_100158.jpg

 

Oh and a back up recoil starter, low oil shut off.....lol 


  • olcowhand, KennyP and Mark 149 J. have said thanks

#6 StinkinLincoln OFFLINE  

StinkinLincoln
  • Member
  • Member No: 89758
  • 4 Thanks
  • 6 posts
  • Location: Top of the world

Posted March 18, 2018 - 09:49 PM

Nice! Looks awesome.



#7 John Arsenault OFFLINE  

John Arsenault
  • Senior Member
  • Member No: 76279
  • 2,918 Thanks
  • 1,321 posts
  • Location: Maine

Posted March 19, 2018 - 08:23 AM

My wife trying out the plow, she did not want to get off it. 

 

1st sweep

https://www.facebook...36617716355276/

 

2nd or 3rd sweeps

https://www.facebook...36614926355555/

 

https://www.facebook...36618669688514/

 
 
This tractor will have a snow blower on it , I only put the plow of it for the time being because I am re-powering my plow tractor. 
 
16 hp is way more then needed to run a plow

  • olcowhand and KennyP have said thanks

#8 secondtry ONLINE  

secondtry
  • Senior Member
  • Member No: 83632
  • 2,153 Thanks
  • 1,530 posts
  • Location: Washington State

Posted March 19, 2018 - 10:39 AM

    Looks like you better learn to cook she may not do it again till the snow is all gone.  Don


  • John Arsenault said thank you




Top