Jump to content

Garden Tractors and Parts on eBay



Photo
- - - - -

Sunstar or DA Dozer Mount


  • Please log in to reply
4 replies to this topic

#1 tractorskipper OFFLINE  

tractorskipper
  • Senior Member
  • Member No: 25019
  • 275 Thanks
  • 213 posts
  • Location: Thomas Mills PA

Posted October 25, 2017 - 01:53 PM

Looking for picture, or other info, of how a snow/dozer blade mounts on a 1920.  Also how the hydraulic lift would connect up.  Have several blades, one of which I would like to adapt to my DA 1920.  I think it would make a great snow pusher.

Could not find a manual that covered the subject for a factory attachment.

 

Thanks

 

Skip



#2 Talntedmrgreen OFFLINE  

Talntedmrgreen

    Simplicity Enthusiast

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 8186
  • 3,218 Thanks
  • 2,293 posts
  • Location: Dorr, MI

Posted October 25, 2017 - 02:50 PM

SS hitch setup...notice the SS lift rod attaches to the upper arm off the rear of the hitch. 

 

SSDozerHitch.jpg

 

 

 

 


  • boyscout862 said thank you

#3 Talntedmrgreen OFFLINE  

Talntedmrgreen

    Simplicity Enthusiast

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 8186
  • 3,218 Thanks
  • 2,293 posts
  • Location: Dorr, MI

Posted October 25, 2017 - 02:50 PM

2017-10-25 15_49_00-Replying To Sunstar or DA Dozer Mount - GTtalk - http___gardentractortalk.com_fo.png

2017-10-25 15_48_41-Replying To Sunstar or DA Dozer Mount - GTtalk - http___gardentractortalk.com_fo.png


  • boyscout862 said thank you

#4 glgrumpy OFFLINE  

glgrumpy

    Getting Out!

  • Senior Member
  • -GTt Supporter-
  • Member No: 8360
  • 8,462 Thanks
  • 7,820 posts
  • Location: Huntington, IN 46750 North East in State

Posted October 25, 2017 - 06:05 PM

This blade for sale?  Fit the 18 hp too? I don't have the dual hydraulics to turn it if needed. But don't see that in this picture.



#5 tractorskipper OFFLINE  

tractorskipper
  • Senior Member
  • Member No: 25019
  • 275 Thanks
  • 213 posts
  • Location: Thomas Mills PA

Posted October 26, 2017 - 09:40 PM

Thanks guys.

 

Skip






Top