Jump to content

Garden Tractors and Parts on eBay



Photo
- - - - -

Case 446 PTO Clutch linkage


  • Please log in to reply
1 reply to this topic

#1 hdshadpar OFFLINE  

hdshadpar
  • Member
  • GTt Junior
  • Member No: 86463
  • 8 Thanks
  • 6 posts
  • Location: Sask.

Posted October 18, 2017 - 10:59 AM

Well everyone it has been a bit of time since my last posting, so I figure I should start an new post since my last one was answered   So I changed all the oils everything worked as intended actually very impressed with the tiller.  Now its time to do the clutch assembly so I have the front end off, pulley etc., believe my shaft will have to be changed account groves in it (I think).  My question now is that I found a parts tractor yesterday and went to dismantle the PTO lever assembly, first we couldn't get the plastic handle off so is there a trick to removing with all the bends in the rod to get it out and then get it back in?  The guy had two different types of a 444 pto rods so I got them and am trying to get them to work on my 446 but I think I will need the assembly I left behind account we could't remove it.  So any suggestions will greatly be appreciated so I can get this ready for the clutch assembly when done.  Tks



#2 boyscout862 ONLINE  

boyscout862
  • Senior Member
  • Contributor
  • Member No: 8923
  • 12,028 Thanks
  • 8,799 posts
  • Location: N.E. Connecticut

Posted October 18, 2017 - 04:41 PM

Have you looked in the manual? Good Luck, Rick






Top