i need to know the the btdc dimension on a h80-155019 . i had the thing running but it was sluggish throtle responce was there but no power. so i pulled the flywheel again and the i proceeded to pull the head . so now i got the indicator set up and ready to go so if any of you guys know what it is it would be very helpful. thank you

another mf8 timming issue need help
Started by
millwright
, Jun 14, 2011 09:42 PM
4 replies to this topic
#1
OFFLINE
Posted June 14, 2011 - 09:42 PM
#2
OFFLINE
Posted June 14, 2011 - 09:52 PM
Millwright, Did you take a look in the manual section, under engines? there are 2 different TEC service manuals there that deal with H80 engines.
- millwright said thank you
#3
OFFLINE
Posted June 14, 2011 - 11:07 PM
I didn't see it in a manual but the two dimensions I was told are .035 and .080 I'm not 100% on those though.
#4
OFFLINE
Posted June 15, 2011 - 05:13 AM
Hopefully the manual can help. I don't know what the dimension is either.
#5
OFFLINE
Posted June 15, 2011 - 08:29 PM
it is .090 btdc and it is all the way in the back of thee manual. you would think that they would put the spec sheet near the timing section . got the thing back together new points and condenser on time and fired first turn of the key.