Garden Tractor Forums banner

Kohler Magnum 8

Tags
sold
1K views 5 replies 4 participants last post by  EricFromPa 
#1 ·
Looking for a complete Kohler Magnum 8 running or not OR just the bearing plate,flywheel with ring gear and magnets,coil,stator,side starter mount,starter,regulator and Blower housing.

Looking to convert 1 of my old K series K181 blocks to solid state ignition with ring gear start and stator charge.

Don't have much money to throw around so any help will be greatly appreciated.

Thanks a bunch

Eric
 
#2 ·
Didn't know they made a Magnum 8. Good luck!
 
#4 · (Edited by Moderator)
Yep they made alot of them. M8ST was commonly used on Troy Bilt horse tillers,gas powered air compressors,cement mixers and a bunch of other stuff.



I want one to convert or replace the K181 in my CC70.There the same thing as a K181.Accually it's the same block and bore size as a K161 just 1/4" longer stroke and slightly higher compression head. If I can get the parts to convert my K181 it's going to save me money in the long run and be more dependable with stator charging and solid state ignition.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top