Jump to content

Garden Tractors and Parts on eBay



Photo
- - - - -

Aftermarket Part Number to MF 16 PTO Pulley


  • Please log in to reply
5 replies to this topic

#1 sozamora72 OFFLINE  

sozamora72
  • Member
  • Member No: 79359
  • 35 Thanks
  • 23 posts
  • Location: Rio Hondo Texas

Posted February 01, 2017 - 10:57 PM

​Anyone have aftermarket part numbers to the front two pulleys off a pto to a MF 16 lawn/garden tractor?  I cant seem to get any cross reference information off the internet.  The help is greatly appreciated.



#2 Bolens 1000 ONLINE  

Bolens 1000

    DR. Bolens

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 7
  • 14,612 Thanks
  • 17,952 posts
  • Location: Western NY

Posted February 02, 2017 - 09:35 AM

What was the OEM numbers?


  • sozamora72 said thank you

#3 sozamora72 OFFLINE  

sozamora72
  • Member
  • Member No: 79359
  • 35 Thanks
  • 23 posts
  • Location: Rio Hondo Texas

Posted February 03, 2017 - 09:19 PM

OEM part number is 842517M2.  Mule drive requires two of these pulleys.



#4 Bolens 1000 ONLINE  

Bolens 1000

    DR. Bolens

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 7
  • 14,612 Thanks
  • 17,952 posts
  • Location: Western NY

Posted February 04, 2017 - 08:23 AM

Found a pic of it, it looks like a simple "V" style pulley, if you can get me the OD, ID of the hole and bushing off sets I likely can get you a new replacement

 

 

Attached Thumbnails

  • s-l1600.jpg

  • DMAX said thank you

#5 sozamora72 OFFLINE  

sozamora72
  • Member
  • Member No: 79359
  • 35 Thanks
  • 23 posts
  • Location: Rio Hondo Texas

Posted February 07, 2017 - 08:50 PM

Thanks for the help.  Bare with me on getting measurements on those pulleys.  My work schedule is unpredictable.  That pic you posted is same one I saw on Ebay.  Saw price listed hence wanting information on aftermarket part number.  Once again thank you and bare with me.



#6 DMAX ONLINE  

DMAX

    Addicted

  • Senior Member
  • Member No: 264
  • 285 Thanks
  • 111 posts
  • Location: Eighty Four, Pa

Posted March 12, 2017 - 05:49 PM

Here are a few photos and dimensions for the v-pulley. Bore ID is 1/2", length of bore is just a hair over 3/4" and is also the same as the width of the pulley. You can see in the picture #2 where I tried using the tape as a straight edge. The OD of the pulley is 4-1/2". I also would like to find a pulley that isn't over $30! I still have one left that's oem but I cannot remember how much I paid for it. It's nice to have few around just in case.

Attached Thumbnails

  • image.jpeg
  • image.jpeg
  • image.jpeg

  • KBuzz said thank you




Top