Is this the right blade for Bolens
Jump to content
Posted September 28, 2016 - 10:32 AM
It looks homemade to me. Does it even pivot? I'd bring measurements if you look at it. Seems expensive to me. Look in the Manuals Section for some of the sales brouchures. Good Luck, Rick
Posted September 28, 2016 - 11:06 AM
I have the same blade and intend to make brackets so it will fit on a QT. Don't have any tubers, so can't help you out there. Good solid blade and, yes, it pivots. Price is too high IMO. Paul
**Edit Mine is setup different, but looks to be made by the same company.
Edited by Paulgo, September 28, 2016 - 11:17 AM.
Posted September 28, 2016 - 04:56 PM
That is a Hydro-Speed blade set-up for a Bolens tubeframe. They were made by Hydro-Speed Equipment, Los Angeles with a branch in Hammond, IN. It was designed to mount in 3 ways: center, front, or rear. The correct pieces appear to all be there. I have one of those for my tubeframes. As for price, well, you don't see them complete very often. The holes in the blade were for mounting a rod with scarifiers on it; the scarifiers and available end plates were extra cost items, so not all of the blades have them.
Posted September 28, 2016 - 06:05 PM