Jump to content

Garden Tractors and Parts on eBay

- - - - -

GT14, OH140 gasket set?

  • Please log in to reply
3 replies to this topic

#1 glgrumpy OFFLINE  


    Getting Out!

  • Senior Member
  • -GTt Supporter-
  • Member No: 8360
  • 8,640 Thanks
  • 7,936 posts
  • Location: Huntington, IN 46750 North East in State

Posted September 05, 2016 - 05:49 PM

Where's good price for a gasket set?  OH140 all I need to know for search? One set fits many hp sizes?  Would need seals for sure, and shims for crank, then would take rings with it if so, don't need piston, rod or anything else that I know of yet. Standard on piston.

  • Sawdust said thank you

#2 Bolens 1000 ONLINE  

Bolens 1000

    DR. Bolens

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 7
  • 15,095 Thanks
  • 18,177 posts
  • Location: Western NY

Posted September 05, 2016 - 06:00 PM

I can get them just PM me if interested

#3 EricFromPa ONLINE  



  • Senior Member
  • Contributor
  • Member No: 2135
  • 3,790 Thanks
  • 3,156 posts
  • Location: Bedford County Pa.

Posted September 05, 2016 - 08:16 PM

Check your crank bearings to.If you see any wear replace them.If there worn they will have a sharp raised lip on the inside of the race.If you had a knock it could of been from worn crank bearings.Engine knock in a tecumseh Is commonly miss diagnosed as worn connecting rod and piston slap.Worn crank bearings will make a knocking sound on every stroke just like connecting rod knock or piston slap.


Crank bearings are the same HH100-OH160 Tecumseh part numbers 31932 and 31928.Bearings are around $40 each and races are around $15 each.


Don't skiimp out on bearings if there worn.They will cause the rod and rings to wear prematurely.

  • Sawdust said thank you

#4 Tecumseh power ONLINE  

Tecumseh power

    Jack of all trades, master of none.

  • Senior Member
  • Member No: 77571
  • 1,512 Thanks
  • 1,123 posts
  • Location: Vintondale pa

Posted September 05, 2016 - 09:29 PM

Pm me if you need help finding anything or if you need help shumming. The crank bearings. Make sure you get every size. And there is 3 different gasket thicknesses to match the shims too