Jump to content

Vote for Tractor of the Month
Garden Tractors and Parts on eBay

- - - - -

Not happy with hilling potatoes

  • Please log in to reply
16 replies to this topic

#16 CanadianHobbyFarmer OFFLINE  

  • Senior Member
  • Member No: 73571
  • 895 Thanks
  • 577 posts
  • Location: Coldwater, Ontario, Canada

Posted May 22, 2016 - 04:38 PM

, I do have a bladder tank that's ready for scrap but would need to figure out how to get the rubber out first



I cut down a bladder tank earlier this year intending to make hillers out of it. I just used a 4-1/2" angle grinder to take the top and bottom off of it. I was surprised at how thin the steel was on mine. This is a project that is currently on hold, but I am probably going to try to find some heavier steel for it. Hoping that yours is heavier than the one I have.



  • Alc said thank you

#17 Alc OFFLINE  



  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 1094
  • 5,278 Thanks
  • 6,482 posts
  • Location: Bangor Pa

Posted May 23, 2016 - 05:13 AM

Thanks for the tip on cutting the bladder tanks open , I think I'm going to try adapting the wings from the Troy furrow maker that I posted the other day .