I'm taking my 54" MF 1855 deck apart and I was wondering how to get the pulleys off the spindle shafts. I didn't see anything in the manual and I figured I'd consult the experts here so I don't damage any parts that are no longer available. Thanks!
MF 1855 Deck Spindle & Pulley Disassembly?
Started by
jpswift1
, Apr 26, 2016 08:13 PM
4 replies to this topic
#1
OFFLINE
jpswift1
-
- Senior Member
- Member No: 69996
- 888 Thanks
- 675 posts
- Location: Buffalo, NY
Posted April 26, 2016 - 08:13 PM
#2
OFFLINE
limebuzz
-
- Senior Member
- Member No: 795
- 1155 Thanks
- 1084 posts
Member
- Location: Bluevale Ontario
Posted April 26, 2016 - 09:11 PM
Take out the bolt and it sledes right off. You might might to loosen the mandrels and back off the tensioners,to give the belts some slack.
- jpswift1 said thank you
#3
OFFLINE
jpswift1
-
- Senior Member
- Member No: 69996
- 888 Thanks
- 675 posts
- Location: Buffalo, NY
Posted April 26, 2016 - 11:34 PM
I loosened the bolts, but didn't try to pull them off quite yet. I have them soaking with penetrating oil now because there was a good amount of rust under the covers so I'll see what happens tomorrow. Thanks!
#4
OFFLINE
ducky
-
- Senior Member
- -GTt Supporter-
- Contributor
- Member No: 564
- 2345 Thanks
- 4320 posts
Senior Member
- Location: Freedom, WI
Posted April 27, 2016 - 09:56 AM
The shafts are steel but the hub in the pulley a plastic material like the belt surface. Sometimes you may have to use a puller with light pressure.
- TheFarm2004 and jpswift1 have said thanks
#5
OFFLINE
jpswift1
-
- Senior Member
- Member No: 69996
- 888 Thanks
- 675 posts
- Location: Buffalo, NY
Posted April 28, 2016 - 08:46 PM
I was able to put a longer bolt into the spindle shafts and tap each one out. I got all 3 out successfully. Thank you!
- TheFarm2004 said thank you
