Will this fit my JD 314?
Posted February 23, 2016 - 06:59 PM
Add says it's for a JD 200 series.
Posted February 23, 2016 - 07:07 PM
Ad is not there. Flat fender 110/112 & 200 series like a blower will not work. A 43 blade will work but you would need to install the hydraulic lift cylinder. Decks drives are different and tillers are right out.
Edited by Trav1s, February 23, 2016 - 07:07 PM.
Posted February 23, 2016 - 09:07 PM
Yes, it does.
The lift bar below the hitch is for the 200 series, the lift bar for the 300 series will attach to the rockshaft below the right foot rest and attach to the tab left of the center pin hole on the sleeve hitch. You will need a 300 series lift bar. The rear lift bar for the 200 series in the pic will fetch a pretty penny, though.
Posted February 23, 2016 - 10:27 PM
- Trav1s said thank you
Posted February 24, 2016 - 06:23 AM
I think someone gave you the link to the plans for a sleeve hitch. The lift bar plans should be included in those plans. It would be pretty simple to make one. Good luck with the purchase!
Posted February 25, 2016 - 09:08 PM
Edited by easternharvest, February 25, 2016 - 09:09 PM.
- limebuzz said thank you
Posted February 26, 2016 - 09:44 AM
Question for all, can anyone tell me what the JD part # is for the lift linkage bar that runs from the rockshaft to the sleeve hitch is for my 314? The hitch I purchased had one from a 210 so I need to find one that fits my GT. Thanks in advance!