Have Poulan chain saw, ran bad at times, hard start, then just quit one day. Those tiny clear fuel lines just fell apart when moving the covers off the carb and handle route. New lines and good to go. Putting the lines INTO the tank is hardest part. I melted and pointed the end to start it in, pulled thru out to cover of tank and snipped off burnt end, pulled back into tank. Same thing for filters, just put it on outside, then pull back in some. First time was going nuts trying to figure out how this TOO big line was gonna go into that hole.
I have the same chain saw, never have got it to run.
Edited by larrybl, February 13, 2016 - 10:20 PM.