Cat 0 3pt box blade.
Posted April 20, 2011 - 09:43 AM
Has anyone here built one, or have one?
Looking for ideas, and do's and dont's.
I would be using it on a Massey Ferguson MF14. (14hp hydrostatic)
Posted April 20, 2011 - 11:09 AM
Posted April 20, 2011 - 06:24 PM
Posted April 20, 2011 - 06:58 PM
Mike, that takes all the fun out, building stuff is almost equal as seat time.
:ditto:Plus, I bet I can do it for more money.
Posted April 20, 2011 - 07:32 PM
Posted April 21, 2011 - 12:20 AM
Posted May 19, 2011 - 05:22 PM
Posted May 19, 2011 - 06:36 PM
Posted May 19, 2011 - 08:06 PM
Whatever happened here, anyway? Did you buy one?
No, didn't buy one. Just hadn't got around to it. Since then, I've rethought this, and maybe this weekend
I'll get around to what I have planned.
I have a small set of tines(sears I think) and a small dozer blade. I'm going to marry the two, but they
will be bolted together.
I have a landscape project I've got to get at soon, and this setup will get me through that. I think.
Posted May 27, 2011 - 09:38 PM
- IamSherwood and KennyP have said thanks
Posted May 29, 2011 - 08:34 AM
Posted May 29, 2011 - 05:22 PM
Posted May 30, 2011 - 11:50 AM
- KennyP said thank you
Posted June 08, 2011 - 09:05 PM
I had a cultivator, and an old dozer blade. Spent an evening, and
turned them into a box blade. I've only spent about an hour using it,
but so far I'm happy with how it works.
The box is 3ft wide, and the blade is 42" behind rear axle.
I haven't taken the time to paint yet, incase it needed tweekin.
Posted June 08, 2011 - 09:12 PM