Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

Manual for LF Front Blade


  • Please log in to reply
4 replies to this topic

#1 chieffan ONLINE  

chieffan
  • Senior Member
  • Contributor
  • Member No: 62695
  • 6,151 Thanks
  • 4,498 posts
  • Location: SW Iowa

Posted November 10, 2015 - 05:44 PM

Looking for a manual for the LF front blade 19904-01.  The 2nd and 3rd numbers are hard to read and either one could be an 8.  Did not find a manual in the manuals section for anything close to that.  Tractor is not running just yet and have a blade and wondering just how it is supposed to attach and if I even have the right parts.  



#2 WrenchinOnIt OFFLINE  

WrenchinOnIt
  • Senior Member
  • -GTt Supporter-
  • Member No: 8592
  • 2,515 Thanks
  • 732 posts

Posted November 10, 2015 - 08:40 PM

Maybe these will help , pic #1 are the frame mounts where pic#2 slide up in between and the clevis pin slides thru all and allows pivot movement plus secures it to unit. Pic#3 are your lift rods and they attach to your rockshaft which allows lift and down pressure via your hydraulic lift cylinder.There are two sets of ears on your rock shaft as you stroke the cylinder you will see how the rockshaft rotates and will pivot the blade via the mounts , attach to the correct set of ears that allows said movement, ( I believe it's the rear most set of ears)

Attached Thumbnails

  • IMG_20151110_194652_hdr_kindlephoto-30357756.jpg
  • post-62695-0-60952900-1443042462_kindlephoto-306087.jpg
  • post-62695-0-60952900-1443042462_kindlephoto-426727.jpg

  • Bolens 1000, OldBuzzard, blackjackjakexxix and 3 others have said thanks

#3 chieffan ONLINE  

chieffan
  • Senior Member
  • Contributor
  • Member No: 62695
  • 6,151 Thanks
  • 4,498 posts
  • Location: SW Iowa

Posted November 11, 2015 - 08:06 AM

Thanks much.  I was trying to figure out how the lift rods worked.  I took them off before i removed the blade from the trailer and forgot just where they went.  Believe it or not all the pins are still with the blade.  Need to make a new swivel lock as the old one was chewed up bad, twisted and bent sideways. That blade had some rough use.  Replaced the swivel bolt right off.



#4 LPBolens OFFLINE  

LPBolens

    Tractorholic

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 874
  • 1,176 Thanks
  • 882 posts
  • Location: North Central Illinois

Posted November 12, 2015 - 08:48 PM

Looking for a manual for the LF front blade 19904-01.  The 2nd and 3rd numbers are hard to read and either one could be an 8. 

The 54" blade that Bolens sold for the early LF's was model #18054. Maybe that is what you have.


  • chieffan said thank you

#5 chieffan ONLINE  

chieffan
  • Senior Member
  • Contributor
  • Member No: 62695
  • 6,151 Thanks
  • 4,498 posts
  • Location: SW Iowa

Posted November 12, 2015 - 09:10 PM

That is very possible the number.  Tractor is a '71.






Top