Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

Interchangability Misprint


  • Please log in to reply
No replies to this topic

#1 chieffan ONLINE  

chieffan
  • Senior Member
  • Contributor
  • Member No: 62695
  • 6,167 Thanks
  • 4,510 posts
  • Location: SW Iowa

Posted September 11, 2015 - 07:18 AM

I was wanting to mount an 18442 deck under a G12.  The chart says "Req.relocate pin in front bolster to higher position."  Checked with another long time Bolens collector and we could not figure out what they meant.  I proceeded to change the deck over.  Removed all the brackets off a 1053 and installed them on the G12.  Everything went on OK, deck is mounted and raises an inch higher than it did on the 1053.  Used a single belt pto which has a smaller pulley, which turns the deck faster.  Works great.  If you mounting a deck under the G series Don't put a lot of faith in the "2" pin relocate requirement.  There is only one hole in the bolster and axle.


  • rustyoldjunk, sodisr, Bolens800uk and 1 other said thanks




Top