Proper Way To Set Up Garden Plow
Posted October 18, 2010 - 11:10 AM
Thank You for the info, I always wondered how to set up a garden tractor plow. Never thought to use a block of wood.
Posted March 31, 2013 - 04:56 PM
That's my next project, My neighbor gave me a near bran new Brinly Plow he had sitting in his garage for near 10 yrs never been used, never had one or messed with one or talked with any one about one, so I set it behind my shed till I could get to it. Then telling my Uncle about it he told me MISTAKE put it inside the shed you don't want rust on it at all. So when I got home I went straight back there dug it out of 18" of snow and put it in the shed, and yes the rust had started :-( had I known sooner.
- Bolens800uk said thank you
Posted March 31, 2013 - 08:07 PM
As long as it is not pitted.......it will clean up with a little bit of plowing...
- Craig. and RodB have said thanks
Posted April 21, 2013 - 07:21 PM
- MH81, Craig. and RodB have said thanks
Posted April 22, 2013 - 04:26 PM
Maggie, glad to have you with us here. If you have some stories to tell us, start a thread. I'm sure folks would be happy to hear them!
Posted April 23, 2013 - 07:30 PM
Posted February 12, 2015 - 12:52 PM
Welcome to the site Maggie. Lot of good folk around these parts with lots of tales and information. Might check out the garden section too.
Posted May 06, 2017 - 07:59 AM
Thanks that will help me setup my plough on my electric garden tractor, I have just made an electric 3 point hitch for it!
video #2 Making an electric 3 point hitch
Posted May 28, 2017 - 11:55 AM
The Brinley plows that don't have the crank to adjust the depth have a slotted hole on the top bolt that attaches the plow assembly to the frame. If you loosen that bolt you can tip the point up or down to adjust the depth of cut. Until I found out about that I had trouble keeping the plow as deep as I wanted it.
- olcowhand said thank you