Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

first start mf-10


  • Please log in to reply
6 replies to this topic

#1 speed005 OFFLINE  

speed005
  • Member
  • Member No: 59263
  • 163 Thanks
  • 80 posts
  • Location: quebec

Posted April 10, 2015 - 08:52 PM

I clean my carburetor and change o ring for new one. Before firt start. I ajust hi speed and idle screw at 1 1/2 turn. the engine start but just with full choke. When close choke engine shot off. Why????

Bad ajustment. Air leak.

#2 speed005 OFFLINE  

speed005
  • Member
  • Member No: 59263
  • 163 Thanks
  • 80 posts
  • Location: quebec

Posted April 10, 2015 - 08:53 PM

The carburator is a walbro lme 37. Engine is hh100

#3 DH1 OFFLINE  

DH1

    Electric Tractors

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 62
  • 4,587 Thanks
  • 5,295 posts
  • Location: Markham Ontario Canada

Posted April 10, 2015 - 08:56 PM

Sometimes you have to play with them a bit.

If it only runs with the choke on then open the high speed jet so it gets more fuel.


Edited by DH1, April 10, 2015 - 08:57 PM.


#4 MH81 OFFLINE  

MH81

    Proud to be Deplorable

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 802
  • 27,269 Thanks
  • 28,607 posts
  • Location: N. W. PA

Posted April 10, 2015 - 09:30 PM

Sounds like you may have a plugged port. May have to take the carb off to clean.
Verify the float is working.
Did you have the carb apart before?

#5 speed005 OFFLINE  

speed005
  • Member
  • Member No: 59263
  • 163 Thanks
  • 80 posts
  • Location: quebec

Posted April 12, 2015 - 04:59 PM

No its the firt time i apart a carb. But its work now. Carb flange was bend.
  • IamSherwood said thank you

#6 IamSherwood OFFLINE  

IamSherwood

    Elf guardian

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 2066
  • 8,379 Thanks
  • 7,696 posts
  • Location: Northern Ontario

Posted April 12, 2015 - 05:33 PM

No its the firt time i apart a carb. But its work now. Carb flange was bend.

 

So, it was sucking too much air. How did you correct that?



#7 speed005 OFFLINE  

speed005
  • Member
  • Member No: 59263
  • 163 Thanks
  • 80 posts
  • Location: quebec

Posted April 12, 2015 - 07:44 PM

Yes. He take air after trotle plate. Venturi do not work. sand flange and change gasket. And is good
  • IamSherwood said thank you




Top