Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

NOS Bush Hog clutch part- trying to figure out what it was used with


  • Please log in to reply
5 replies to this topic

#1 sacsr OFFLINE  

sacsr

    Bush Hog Addict

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 4776
  • 3,268 Thanks
  • 3,283 posts
  • Location: Eastern NC

Posted December 22, 2014 - 11:57 AM

This part is just like the other one (s-2662 both have same number part?) but this one has the double pulley set up. So far I have not figured out what implement it went with.........
image.jpg image.jpg image.jpg
  • Texas Deere and Horse said thank you

#2 crittersf1 OFFLINE  

crittersf1

    GT Lunatic

  • Senior Member
  • Member No: 26142
  • 4,169 Thanks
  • 5,761 posts
  • Location: Newport, N.C.

Posted December 22, 2014 - 02:02 PM

If you don't know........


  • sacsr said thank you

#3 Titus OFFLINE  

Titus

    Bush Hog Hoarder

  • Senior Member
  • Member No: 4216
  • 1,736 Thanks
  • 2,250 posts
  • Location: Coventry RI

Posted December 22, 2014 - 04:46 PM

Hydro pump would be my vote.


  • sacsr said thank you

#4 Titus OFFLINE  

Titus

    Bush Hog Hoarder

  • Senior Member
  • Member No: 4216
  • 1,736 Thanks
  • 2,250 posts
  • Location: Coventry RI

Posted December 22, 2014 - 04:47 PM

post-4216-0-54809400-1337456922.jpg



#5 EricFromPa OFFLINE  

EricFromPa

    Tractorholic

  • Senior Member
  • Contributor
  • Member No: 2135
  • 2,304 Thanks
  • 2,336 posts
  • Location: Bedford County Pa.

Posted December 22, 2014 - 05:53 PM

Looks Very similar to the old Cub Cadet Engine PTO pulleys.Only difference I can see is the 2 Belt slots and a bit bigger.

 

$_57.JPG $_571.JPG $_572.JPG

 

 

 

It's definitely a Brush Hog PTO pulley but it has an "Auxiliary?" belt groove for I would say an auxiliary Hydro pump?.Looks like it would fit the HD-12.

 

I could think of a couple cool uses for that.PTO powered air compressor or Generator would be neat.

 

 

BH.jpg


Edited by EricFromPa, December 22, 2014 - 06:12 PM.

  • sacsr said thank you

#6 sacsr OFFLINE  

sacsr

    Bush Hog Addict

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 4776
  • 3,268 Thanks
  • 3,283 posts
  • Location: Eastern NC

Posted December 23, 2014 - 07:42 AM

You may be right. I do have most of a hydraulic lift kit for a D4-10 series tractor. The pump was run off of a double pulley on the starter/generator. I am going to do more research......maybe it was for the Ark loader that was used on these tractors. I have never seen a diagram or list of parts for it.






Top