Garden Tractor Forums banner

Question

753 views 3 replies 3 participants last post by  MRFUNKTASTIC 
#1 ·
First off great forum and thanks for all the knowledge within this forum!!

My question is I have a kubota b5200 with a d750 diesel the motor started with a slapping noise after it overheated. I also have a kubota g5200h with a d600 diesel and was wondering if the motor would fit it as far as clutch and bell housing plate. I have looked everywhere to see if its the same bolt pattern or not
 
#3 ·
It should be the same you may need to swap over everything bell housing related as well as flywheel but it should work just fine.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top