I need a Wisconsin Engine flywheel
Posted February 05, 2011 - 05:12 PM
This is for the new 800 Michelle and I just pick up today.
Posted February 05, 2011 - 05:38 PM
Posted February 05, 2011 - 06:04 PM
From the Book I was looking at the flywheels appear to be interchangeable..... I am not 100% sure though because I dont have that much information on the S7-D's to go off of.
Are you going to run the magneto or use the Coil ignition? Make shure you get the flywheel with the magnet in it if you use the Mag.
Posted February 05, 2011 - 06:17 PM
Posted February 05, 2011 - 08:00 PM
Posted February 05, 2011 - 08:31 PM
I have one off an S-8D, but need to make sure it has no cracks or anything else wrong with it. I'll get back with you tomorrow.
If its good, get the numbers off it and I'll compare them to mine. The Wisconsin Engine parts manual shows different flywheels for the two engines.
Posted February 07, 2011 - 11:59 AM
Posted February 07, 2011 - 07:21 PM
Sorry for the delay. I laid it on the well house yesterday, then....forgot! It has no cracks & keyway perfect...just a bit dirty is all. Wico #Y12968
Thats what I have, so I'll take it and try. Send me a private message with cost. Thanks Adam
Posted February 07, 2011 - 07:49 PM
Posted February 07, 2011 - 08:15 PM
PM sent, and I will clean it before shipping.
Sounds like a great deal. Thanks again.