Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

Mf 14 Hydro Lever Shaft Bushings


  • Please log in to reply
5 replies to this topic

#1 Gabriel OFFLINE  

Gabriel
  • Senior Member
  • Contributor
  • Member No: 52459
  • 1,440 Thanks
  • 1,858 posts
  • Location: East Central Indiana

Posted January 30, 2014 - 10:28 PM

Are replacement bushings for the hydro lever shaft hard to find? I'm not sure if mine are bad(one looks like it is crumbling on the outside, but may not affect use). Jack's says that they are not available.



#2 IamSherwood OFFLINE  

IamSherwood

    Elf guardian

  • Senior Member
  • -GTt Supporter-
  • Contributor
  • Member No: 2066
  • 8,379 Thanks
  • 7,696 posts
  • Location: Northern Ontario

Posted January 31, 2014 - 03:56 AM

These guys?

 

http://gardentractor...es/#entry256906

 

I'm pretty sure they're the same as the mower lift shaft, but check the dimensions.


  • olcowhand and Gabriel have said thanks

#3 olcowhand ONLINE  

olcowhand

    Red Tractor Nut & Diesel Addict

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Sponsor
  • Contributor
  • Member No: 20
  • 35,561 Thanks
  • 29,819 posts
  • Location: South Central Kentucky

Posted January 31, 2014 - 08:55 AM

These guys?

 

http://gardentractor...es/#entry256906

 

I'm pretty sure they're the same as the mower lift shaft, but check the dimensions.

 

I am thinking the hydro shaft bushings are a different size.  One is (as I kind of recall) is 1/8" smaller in size than the other.  I can go check the old MF14 frame carcass out back.


  • IamSherwood and Gabriel have said thanks

#4 Gabriel OFFLINE  

Gabriel
  • Senior Member
  • Contributor
  • Member No: 52459
  • 1,440 Thanks
  • 1,858 posts
  • Location: East Central Indiana

Posted January 31, 2014 - 10:18 AM

I just looked at my parts book and the lift shaft uses a different bushing.



#5 olcowhand ONLINE  

olcowhand

    Red Tractor Nut & Diesel Addict

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Sponsor
  • Contributor
  • Member No: 20
  • 35,561 Thanks
  • 29,819 posts
  • Location: South Central Kentucky

Posted January 31, 2014 - 10:27 AM

These guys?

 

http://gardentractor...es/#entry256906

 

I'm pretty sure they're the same as the mower lift shaft, but check the dimensions.

 

 

I just edited the linked page, as the rockshaft is 7/8" ID, while the hydro lever is 3/4", which the linked bushings will work on.  These bushings can however be bored out to make their ID 7/8" so they then WOULD fit the lift rock-shaft.


  • IamSherwood and Gabriel have said thanks

#6 Gabriel OFFLINE  

Gabriel
  • Senior Member
  • Contributor
  • Member No: 52459
  • 1,440 Thanks
  • 1,858 posts
  • Location: East Central Indiana

Posted January 31, 2014 - 01:15 PM

Great!




Top