Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

Just Bought a Bush Hog T-63


  • Please log in to reply
78 replies to this topic

#76 mjodrey OFFLINE  

mjodrey

    Accumulator

  • Senior Member
  • Contributor
  • Member No: 92
  • 2,343 Thanks
  • 13,481 posts
  • Location: Upper Granville, Nova Scotia, Canada

Posted January 30, 2011 - 09:08 AM

Just run her around in your workshop,no mud there.:laughingteeth::laughingteeth:

#77 olcowhand OFFLINE  

olcowhand

    Red Tractor Nut & Diesel Addict

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Sponsor
  • Contributor
  • Member No: 20
  • 35,648 Thanks
  • 29,840 posts
  • Location: South Central Kentucky

Posted January 30, 2011 - 09:22 AM

Just run her around in your workshop,no mud there.:laughingteeth::laughingteeth:


I could go about 10 inches fore & aft....not much of a run Maynard! :rofl2:

#78 mjodrey OFFLINE  

mjodrey

    Accumulator

  • Senior Member
  • Contributor
  • Member No: 92
  • 2,343 Thanks
  • 13,481 posts
  • Location: Upper Granville, Nova Scotia, Canada

Posted January 30, 2011 - 09:34 AM

I could go about 10 inches fore & aft....not much of a run Maynard! :rofl2:


I figured that.LOL

#79 olcowhand OFFLINE  

olcowhand

    Red Tractor Nut & Diesel Addict

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Sponsor
  • Contributor
  • Member No: 20
  • 35,648 Thanks
  • 29,840 posts
  • Location: South Central Kentucky

Posted March 21, 2011 - 06:46 PM

Mowed around my house with the T-63 just a few minutes ago. She runs good as new, with not a hint of smoke. Mows well too, but since someone welded the PTO sliding sheave halves together, I can't throw the deck out of gear. The Delco starter/gen cranks her right up even with deck engaged though, so not a real biggie. Only thing I can tell wrong is the driveshaft bearing in the rear of bell housing is dry, so may have to tear that apart soon if I wanna use it. I'd like to get it out now & then to mow. Maybe I get use a grease needle & get some grease in there & quiet/smooth it down.




Top