Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
- - - - -

Brooklyn, Ct Swap Meet


  • Please log in to reply
3 replies to this topic

#1 boyscout862 ONLINE  

boyscout862
  • Senior Member
  • Member No: 8923
  • 9,763 Thanks
  • 7,534 posts
  • Location: N.E. Connecticut

Posted October 13, 2013 - 12:36 PM

I got a late start today. The weather was cloudy and raw. There was fewer people and dealers than
I expected. Learned why yesterday and today were small. The huge one in PA and there is a big one in RI this weekend.

 

I found one thing, it is a quad or GT lift, missing the hydraulic cylinder but it was only $7. Hopefully it will make work easier. I have been looking for a Zenith 1408 carb. I'll have to make the boring bit and bushings. Good Luck, Rick

 

SD530664.JPG I lifts to 17"


Edited by boyscout862, October 13, 2013 - 12:52 PM.

  • Texas Deere and Horse and Sawdust have said thanks

#2 chris m ONLINE  

chris m

    Tractorholic

  • Super Moderator
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 8148
  • 3,277 Thanks
  • 4,033 posts
  • Location: Charlestown,Rhode Island

Posted October 13, 2013 - 01:42 PM

Rick put a wanted ad on our site for the carb you need.

 

Just also put what engine it is for and make of GT.  I'm guessing it must be and old Wisconsin S10D (or close to it) Maybe on a Bolens?

 

I was hoping to get over to Swap Yankee days but didn't happen.


  • boyscout862 said thank you

#3 boyscout862 ONLINE  

boyscout862
  • Senior Member
  • Member No: 8923
  • 9,763 Thanks
  • 7,534 posts
  • Location: N.E. Connecticut

Posted October 13, 2013 - 05:51 PM

Rick put a wanted ad on our site for the carb you need.

 

Just also put what engine it is for and make of GT.  I'm guessing it must be and old Wisconsin S10D (or close to it) Maybe on a Bolens?

 

I was hoping to get over to Swap Yankee days but didn't happen.

Its a Bolens 1250 with an S12D Wisconsin. If worse comes to worse I will make the throttle shaft and bushings. When are you coming for the tractor? Good Luck, Rick



#4 Sawdust OFFLINE  

Sawdust
  • Senior Member
  • Member No: 36549
  • 4,521 Thanks
  • 2,829 posts
  • Location: Butler, Kentucky

Posted October 13, 2013 - 07:39 PM

That will make a nice little project. It shouldn't be too hard to get that thing lifting...maybe an electric cylinder with a foot switch.


  • boyscout862 said thank you




Top