Jump to content

Nominations for Tractor of the Month
Garden Tractors and Parts on eBay



Photo
* * * * * 1 votes

Busy Weekend!


  • Please log in to reply
34 replies to this topic

#31 KennyP ONLINE  

KennyP

    FORDoholic

  • Super Moderator
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 2253
  • 28,413 Thanks
  • 39,663 posts
  • Location: Collinsville, Oklahoma

Posted September 09, 2013 - 07:57 PM

Not to bust a bubble, but I'm afraid that pump is a low pressure water/spray pump.  Notice how it says "flush with oil after use", and it only has one shaft.  Vane pumps only have one shaft, but it's not a vane pump.  Looks to be a "roller pump".

Thanks, Daniel! I started a thread on the pump trying to figure this all out! But I do have 2 Char-Lynn hyd. motors and valve!


  • Texas Deere and Horse said thank you

#32 Texas Deere and Horse OFFLINE  

Texas Deere and Horse

    RED Wild Hogs, Horses & Deeres

  • Staff Admin
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 1435
  • 14,464 Thanks
  • 15,392 posts
  • Location: East of San Antonio Texas

Posted September 09, 2013 - 08:23 PM

Not to bust a bubble, but I'm afraid that pump is a low pressure water/spray pump.  Notice how it says "flush with oil after use", and it only has one shaft.  Vane pumps only have one shaft, but it's not a vane pump.  Looks to be a "roller pump".

 

Boy Daniel, You don't miss anything. That pump is upside down, had to turn my head to read that, good eyes my friend!!



#33 BTS ONLINE  

BTS

    Make Stuff Up

  • Senior Member
  • Contributor
  • Member No: 11851
  • 2,733 Thanks
  • 1,727 posts
  • Location: BURNS KS

Posted September 10, 2013 - 06:56 AM

Char-lynn also made power steering for old tractors, I had a WD45 with Char-Lynn Power steering and I have a smaller old loader that has it too.

(Useless information for the day!) :D

 

Those garden tractors look great! good luck and have fun with them


  • KennyP said thank you

#34 KennyP ONLINE  

KennyP

    FORDoholic

  • Super Moderator
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 2253
  • 28,413 Thanks
  • 39,663 posts
  • Location: Collinsville, Oklahoma

Posted September 10, 2013 - 04:46 PM

One thing I noticed on the GTV/16, it has a cast front axle. Also has 6" wheels on it. Odd!



#35 KennyP ONLINE  

KennyP

    FORDoholic

  • Super Moderator
  • Staff
  • -GTt Supporter-
  • Contributor
  • Member No: 2253
  • 28,413 Thanks
  • 39,663 posts
  • Location: Collinsville, Oklahoma

Posted September 13, 2013 - 06:20 PM

I worked over the blade a bit. The pin for the angle adjustment was rusted solid. A little help with the Mapp Gas and we have a functioning blade. I got it out finally and cleaned the rust away. A bit of anti-seize and it's good to go.






Top