Well the fate an future of the 129 is at a hault Shane pulled it apart and got the motor on the work bench last week.(wed or thursday) Friday i went out after class got the heater going and proceded to take the flywheel off then the engine cover behind the flywheel.and wht we thought had happened was the rod was laying in the bottom of the block no big deal i thought, I started pullong out othe pieces not just the pieces of the rod so from what i saw no big deal he just need a rod an piston. I get the piston out look it over and look at the pieces i have when i realize i have a few more pieces then i should have i look down the bore and notice part of the bore towrds the bottom is missing a chunk i looked the pieces over and part of the cyl. bore is on the bench with the other pieces. Can this be bored out and resleaved or is it time for a new motor for this 129?
Need To Move A Hydro Cub 129
Posted February 10, 2013 - 08:27 PM
Posted February 10, 2013 - 08:52 PM
Posted February 11, 2013 - 09:35 AM
i can try to take some of the block when i get home today from class an either upload them today or tomorrow
Posted February 12, 2013 - 11:15 AM
well here are all the pieces i pulled outa the block
- CRFarnsworth and twostep have said thanks
Posted February 12, 2013 - 11:26 AM
Ouch! That don't look so good!
Posted February 12, 2013 - 11:32 AM
ive seen a lot with broke rods before but this one wins so far its a mess im hoping it can be fixed
Posted February 12, 2013 - 06:08 PM
Wow, that is bad!!! Hopefully you will be able to repair it.
Posted February 13, 2013 - 09:45 AM
im hoping it can be shane has been busy working on his house so he hasnt been down to see what i needs then from there ill get ahold of a machine shop and see how much to get it bored and sleeved then get it running again
Posted February 13, 2013 - 10:42 AM
How bad is the block? Can you show a photo of the damage?