I am not at home where I can measure the engine pulley (unfortunately), but am looking to start the design for the pulley reduction/chain reversal PTO system. I am looking to take power off the engine on the smallest pulley (right before the rubber reverse wheel). Any Idea what the diameter of this pulley is.. and what size belt is compatible?
I did a search and came up dry. The parts manual doesn't give specs on the T70 pulley.
What Is The Diameter And Belt Type For The Engine Pulley?
Started by
BowDown
, Jun 18, 2012 08:52 AM
5 replies to this topic
#1
OFFLINE
BowDown
-
- Senior Member
- Member No: 10128
- 462 Thanks
- 539 posts
- Location: Central, NY
Posted June 18, 2012 - 08:52 AM
#2
OFFLINE
BowDown
-
- Senior Member
- Member No: 10128
- 462 Thanks
- 539 posts
- Location: Central, NY
Posted June 18, 2012 - 11:03 AM
This is all I could find on the belt? Can anyone confirm?
#3
OFFLINE
Lmiller3358
-
- Senior Member
- Member No: 5109
- 1,466 Thanks
- 1,411 posts
Member
- Location: Massachusetts
Posted June 20, 2012 - 06:24 AM
I'll measure my forward pulley Bow, and get the belt number for the drive, i just put a new belt on....
#4
OFFLINE
BowDown
-
- Senior Member
- Member No: 10128
- 462 Thanks
- 539 posts
- Location: Central, NY
Posted June 20, 2012 - 07:44 AM
Excellent. Thank you sir.
#5
OFFLINE
Lmiller3358
-
- Senior Member
- Member No: 5109
- 1,466 Thanks
- 1,411 posts
Member
- Location: Massachusetts
Posted June 21, 2012 - 03:05 PM
Sorry for the delay Bow, the front 4 bolt pulley on my machine is 3 1/2 inches outiside diameter, I use a Gates 6833 green belt on the drive pulley's
#6
OFFLINE
BowDown
-
- Senior Member
- Member No: 10128
- 462 Thanks
- 539 posts
- Location: Central, NY
Posted June 21, 2012 - 07:03 PM
Great! Thank you much. Now when my mid-mount PTO box arrives i can figure out the reduction and order up my pulley.
Sent from my cell.
Sent from my cell.
