I Finally Have One, T75!
Posted November 20, 2012 - 09:43 PM
Posted December 02, 2012 - 05:21 PM
Yes, it does suck. Just mix up a little and brush it on. It's a pain, but it's worth it.
Here is a better shot of paint from gas drip. I'm not going to paint it
for now, It gives it character.
Posted December 02, 2012 - 05:23 PM
Posted December 02, 2012 - 05:27 PM
I have a small work bench and its warm down there.
Posted December 02, 2012 - 05:31 PM
Posted December 02, 2012 - 05:41 PM
Ita a perpetual motion machine. I stuck the gas line
in the end of the muffler just to keep it out of the
way while I lifted the engine out of the tractor.
Well the exhaust gas is now going in the fuel line
and back through the carburetor and filling
the float bowl and keepin the engine running.
I'm not making this up, Honest.
I also have land for sale if anyone is interested
Posted December 02, 2012 - 09:31 PM
Posted December 03, 2012 - 08:43 AM
Posted December 03, 2012 - 10:47 PM
Posted December 04, 2012 - 05:57 AM
valve has about 1/64" side play and no valve giude to replace.
Does anyone have or know where I can get repair
manual for a 170401 7 hp engine?
Posted December 04, 2012 - 06:15 AM
I wanta see a motor running off exhaust. Vids or it aint true
Yes,I'd like to see that myself.
Posted December 04, 2012 - 07:25 AM
Posted December 04, 2012 - 10:38 PM
Posted December 07, 2012 - 08:37 AM
Posted December 12, 2012 - 11:32 PM
I had to take off about .010" of an inch to get it to clean up.
I then polished inside the combustion chamber to give it
a good cleaning. the piston has a few small scratches
in it but otherwise good shape. The block had a big
seam or ridge inside the intake port from when block was cast.
I took my dremmel and cleaned that up.