Removing Bearings from 850 Clutch Assembly
Posted June 18, 2010 - 08:18 AM
i just removed the retaining ring from the larger clutch flange and don't know how to get this part out (the rectangular thing that attaches to the yoke). i think i'll punch it from the other side. it looks like some spindles have already been broken off.
second. on the pulley assembly, there is a spacer and two needle bearings. right now, nothing spins. when i put it on the drive shaft and spin it, it spins inside the spacer. i'll know more when i pop them out, but it seems like the spacer should spin?
thanks for all the help,
Posted June 18, 2010 - 08:39 AM
Posted June 18, 2010 - 11:25 AM
i'm driving to go pick up a new pair at Applied Industries in Sydney, OH.
sam said to just use another piece of steel to pull the whole thing together for the baking.
i'll give you an update soon...
Posted June 21, 2010 - 03:34 PM
I got the whole tractor put back together and the lawn is mowed! Thank you all for your support and advice.
It was definitely harder to put back together. I learned some new things! I still haven't got the clutch pedal set up perfect yet, but the whole tractor runs much better, especially when engaging the clutch in a high gear and a load.
Posted June 21, 2010 - 04:36 PM
Did you have any trouble baking on the discs?
Lets see some pics with the deck on!
Posted June 22, 2010 - 06:08 PM
baking the discs on was the easiest part. this is what my shish kabab looked like going in the oven. worked great.
and here's the clouds that rolled in when i was finishing up...
again, thank you all for your support!
Posted June 23, 2010 - 05:18 AM
Posted June 23, 2010 - 05:41 AM
Very Nice 850!
Thanks for the pics